Ruler

How to Use the Ruler Tool

1. Open up your project and select the Ruler icon at the top of your screen

   

2. Select on the Map where you want to trace your Ruler, to close the ruler select on the point you started with, followed by the Confirm button or Enter Button of your keyboard

Editing a Ruler in the Inspector Panel

1. After you Measurements are established the inspector Panel will appear on the right side of your screen

   

2. Change the Name of your Ruler tool at the top of the Inspector Panel, followed by the green check mark

   

3. Look the total length / Area of your Ruler beneath the Layer Name

   

4. Within the lays tab select on “Distance Unit” to adjust your measurement units

   

5. Within the lays tab select on “Area Unit” to adjust your area measurement units

   

6. Select the “Convert to Polygon” to convert your measurements to a Polygon or Line

Exporting & Downloading a Measurement

1. Select on the “Data Tab” followed by your file type then download to export your measurement

Delete a Measurement

1. Select on the “Delete” Button in the bottom right corner of the inspector panel to delete a measurement layer